Mpls-Ce Connected To Pe - Cisco ASR 5000 Administration Manual
Staros release 21.1
Hide thumbs
Also See for ASR 5000:
- Installation manual (294 pages) ,
- Administration manual (159 pages) ,
- Installation procedure (8 pages)
Table of Contents
Advertisement
BGP MPLS VPNs
MPLS-CE Connected to PE
MPLS-CE Connected to PE
In this scenario the ASR 5x00 functions as an MPLS-CE (Customer Edge) network element connected to a
Provider Edge (PE) Label Edge Router (LER), which in turn connects to the MPLS core (RFC 4364). See the
figure below.
Figure 19: ASR 5x00 MPLS-CE to PE
The MPLS-CE functions like a PE router within its own Autonomous System (AS). It maintains Virtual
Routing and Forwarding (VRF) routes and exchanges VPN route information with the PE via an MP-eBGP
(Multi-Protocol-external BGP) session.
The PE is also configured with VRFs and exchanges VPN routes with other PEs in its AS via MP-iBGP
(Multi-Protocol-internal BGP) connections and the MPLS-CE via an MP-eBGP connection.
The EBGP connection allows the PE to change next-hop IP addresses and labels in the routes learned from
IBGP peers before advertising them to the MPLS-CE. The MPLS-CE in this case uses only MP-eBGP to
advertise and learn routes. Label Distribution Protocol (LDP) and Resource Reservation Protocol (RSVP) are
not required because of direct-connect EBGP peering. The MPLS-CE in this scenario pushes/pops a single
label (learned over the MP-eBGP connection) to/from the PE.
ASR 5000 System Administration Guide, StarOS Release 21.1
290
Advertisement
Table of Contents
Troubleshooting
