Asr 5000 System Administration Guide, Staros Release 21.1 - Cisco ASR 5000 Administration Manual
Staros release 21.1
Hide thumbs
Also See for ASR 5000:
- Installation manual (294 pages) ,
- Administration manual (159 pages) ,
- Installation procedure (8 pages)
Table of Contents
Advertisement
Configuring the System for Remote Access
The CLI output should be similar to the sample output:
context local
interface
ip address
exit
subscriber default
exit
administrator
no server telnetd
no server ftpd
ssh generate key
server sshd
subsystem sftp
exit
port ethernet 24/1
bind interface
exit
port ethernet 24/1
no shutdown
exit
snmp engine-id local 800007e580ed826c191ded2d3d
end
Step 8
Verify the configuration of the IP routes by entering the following command:
host_name
[local]
The CLI output should be similar to the sample output:
"*" indicates the Best or Used route.
Destination
*0.0.0.0/0
network
*
Step 9
Verify the interface binding by entering the following command:
host_name
[local]
interface_name is the name of the interface that was configured in step 7b.The CLI output should be similar to the sample
output:
Intf Name:
Intf Type:
Description:
IP State:
IP Address:
Bcast Address:
Resoln Type:
L3 monitor LC-port switchover:
Number of Secondary Addresses:
Step 10
Save your configuration as described in Verifying and Saving Your Configuration.
ASR 5000 System Administration Guide, StarOS Release 21.1
26
interface_name
ipaddress subnetmask
admin_name
password
interface_name
local
show ip route
#
Nexthop
Protocol
ipaddress
static
0.0.0.0
connected
show ip interface name interface_name
#
spio1
Broadcast
UP (Bound to 24/1 untagged, ifIndex 402718721)
ipaddress
bcastaddress
ARP
Disabled
0
admin_password
Prec Cost Interface
1
0
spio1
0
0
spio1
Subnet Mask:
MTU:
ARP timeout:
Getting Started
subnetmask
1500
3600 secs
Advertisement
Table of Contents
Troubleshooting
