Applying An Acl To The Subscriber Named Default - Cisco ASR 5000 Administration Manual
Staros release 21.1
Hide thumbs
Also See for ASR 5000:
- Installation manual (294 pages) ,
- Administration manual (159 pages) ,
- Installation procedure (8 pages)
Table of Contents
Advertisement
Access Control Lists
ip access-group
ip access-group
exit
aaa group default
exit
gtpp group default
exit
content-filtering server-group
response-timeout
connection retry-timeout
Applying an ACL to the Subscriber Named default
This section provides information and instructions for applying an ACL to the subscriber named default.
Important
To configure the system to provide access control list facility to subscribers:
Step 1
Apply the configured access control list by following the example configuration in
Named default, on page 241
Step 2
Verify that ACL is applied properly on interface by following the steps in
Subscriber Named default, on page 242
Step 3
Save your configuration to flash memory, an external memory device, and/or a network location using the Exec mode
save configuration command. For additional information refer to the Verifying and Saving Your Configuration chapter.
Applying an ACL to the Subscriber Named default
To apply the ACL to the subscriber named default, use the following configuration:
configure
context acl_ctxt_name [ -noconfirm ]
Notes:
• The context name is the name of the ACL context containing the interface to which the ACL is to be
access_group_name
access_group_name
response_timeout
retry_timeout
end
This section provides the minimum instruction set for applying the ACL list to all traffic within a context.
For more information on commands that configure additional parameters and options, refer to Subscriber
Configuration Mode Commands in the Command Line Interface Reference.
subscriber name subs_name
{ ip | ipv6 } access-group acl_list_name [ in | out ]
end
applied.
Applying an ACL to the Subscriber Named default
in
out
cfsg_name
ASR 5000 System Administration Guide, StarOS Release 21.1
Applying an ACL to the Subscriber
Verifying the ACL Configuration to the
241
Advertisement
Table of Contents
Troubleshooting
