Table of Contents
Advertisement
6.3.4
Exiting the Intel
SATA Option ROM utility
To exit the utility:
1.
From the utility main menu, select 4. Exit then press <Enter>.
2.
Press <Y> to exit or press <N> to return to the utility main menu.
6.3.5
Rebuilding the RAID
This option is only for the RAID 1 set.
Rebuilding the RAID with other non-RAID disk
If any of the SATA hard disk drives included in the RAID 1 array failed, the system displays
the status of the RAID volume as "Degraded" during POST. You can rebuild the RAID array
with other installed non-RAID disks.
To rebuild the RAID with other non-RAID disk:
1.
During POST, press <Ctrl>+<I> at the prompt to enter the Intel Rapid Storage
Technology option ROM utility.
2.
If there is a non-RAID SATA Hard Disk available, the utility will prompt you to rebuild
the RAID. Press the up/down arrow keys to select the destination disk then Press
<Enter> to start the rebuilding process, or press <ESC> to exit.
"Degraded" volume and disk available for rebuilding detected. Selectign
a disk initiates a rebuild. Rebuild completes in the operating system.
Select the port of destination disk for rebuilding (ESC to exit):
Port
Drive Model
X
XXXXXXXXXXX
Select a destination disk with the same size as the original hard disk.
RS720Q-E8-RS12
®
Rapid Storage Technology enterprise
[
CONFIRM EXIT
Are you sure you want to exit? (Y/N):
[
DEGRADED VOLUME DETECTED
Serial #
XXXXXXXX
[
]-Previous/Next [ENTER]-Select [ESC]-Exit
]
]
Size
XXX.GB
6-29
Advertisement
Chapters
Table of Contents
