Table of Contents
Advertisement
6.3
Intel
Option ROM Utility
The Intel
Rapid Storage Technology enterprise SATA Option ROM utility allows you to
®
create RAID 0, RAID 1, RAID 10 (RAID 1+0), and RAID 5 set from Serial ATA hard disk
drives that are connected to the Serial ATA connectors supported by the Southbridge.
Before you proceed, ensure that you have installed the Serial ATA hard disk drives, have
set the correct jumper settings of the motherboard, and have set the correct SATA mode in
the BIOS setup. You can refer to the Installing hard disk drives, Setting Jumpers, and
Setting the RAID mode sections in BIOS for more information.
To launch the Intel
1.
Turn on the system.
2.
During POST, press <Ctrl>+<I> to display the utility main menu.
Intel(R) Rapid Storage Technology enterprise - SATA Option ROM - 3.6.0.1023
RAID Volumes:
None defined.
Physical Disks:
ID
0
1
2
3
[
The navigation keys at the bottom of the screen allow you to move through the menus
and select the menu options.
The RAID BIOS setup screens shown in this section are for reference only and may not
exactly match the items on your screen.
6-24
®
Rapid Storage Technology enterprise SATA
Rapid Storage Technology enterprise SATA Option ROM utility:
®
Copyright(C) 2003-12 Intel Corporation.
1. Create RAID Volume
2. Delete RAID Volume
[
DISK/VOLUME
Drive Model
Serial #
ST3300656SS
HWAS0000991753TR
ST3300656SS
37VN00009846RAJ1
ST3300656SS
397600009846UEDY
ST3300656SS
GWC50000991756G6
]-Select
All Rights Reserved.
[
MAIN MENU
]
3. Reset Disks to Non-RAID
4. Exit
INFORMATION]
Size
279.3GB
279.3GB
279.3GB
279.3GB
[ESC]-Exit
[ENTER]-Select Menu
Type/Status(Vol ID)
Non-RAID Disk
Non-RAID Disk
Non-RAID Disk
Non-RAID Disk
Chapter 6: RAID configuration
Advertisement
Chapters
Table of Contents
