Enabling Ldp Auto-Configuration For A Specified Ospf Instance - Cisco CRS Configuration Manual
Ios xr mpls configuration guide
Hide thumbs
Also See for CRS:
- User manual (304 pages) ,
- Configuration manual (292 pages) ,
- Command reference manual (155 pages)
Table of Contents
Advertisement
Implementing MPLS Label Distribution Protocol
Command or Action
Related Topics
IGP Synchronization Process Restart Delay, on page 18
Enabling LDP Auto-Configuration for a Specified OSPF Instance
Perform this task to enable IGP auto-configuration globally for a specified OSPF process name.
You can disable auto-configuration on a per-interface basis. This lets LDP enable all IGP interfaces except
those that are explicitly disabled.
This feature is supported for IPv4 unicast family in default VRF only.
Note
SUMMARY STEPS
1. configure
2. router ospf process-name
3. mpls ldp auto-config
4. area area-id
5. interface type interface-path-id
6. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Enabling LDP Auto-Configuration for a Specified OSPF Instance
Purpose
• Yes— Saves configuration changes and exits the
configuration session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
59
Advertisement
Table of Contents
