Configuring Unequal Load Balancing; Setting Unequal Load Balancing Parameters - Cisco CRS Configuration Manual
Ios xr mpls configuration guide
Hide thumbs
Also See for CRS:
- User manual (304 pages) ,
- Configuration manual (292 pages) ,
- Command reference manual (155 pages)
Table of Contents
Advertisement
Configuring Unequal Load Balancing
Related Topics
MPLS-TE Forwarding Adjacency Benefits, on page 183
Configure Forwarding Adjacency: Example, on page 349
Configuring Unequal Load Balancing
Perform these tasks to configure unequal load balancing:
•
•
Setting Unequal Load Balancing Parameters
The first step you must take to configure unequal load balancing requires that you set the parameters on each
specific interface. The default load share for tunnels with no explicit configuration is the configured bandwidth.
Equal load-sharing occurs if there is no configured bandwidth.
Note
SUMMARY STEPS
1. configure
2. interface tunnel-te tunnel-id
3. load-share value
4. Use the commit or end command.
5. show mpls traffic-eng tunnels
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
interface tunnel-te tunnel-id
Example:
RP/0/RP0/CPU0:router(config)# interface
tunnel-te 1
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
278
Setting Unequal Load Balancing Parameters, on page 278
Enabling Unequal Load Balancing, on page 279
Purpose
Enters global configuration mode.
Configures an MPLS-TE tunnel interface configuration mode and
enables traffic engineering on a particular interface on the originating
node.
Only tunnel-te interfaces are
Note
permitted.
Implementing MPLS Traffic Engineering
Advertisement
Table of Contents
