Define A Range For Static Mpls Labels - Cisco CRS Configuration Manual
Ios xr mpls configuration guide
Hide thumbs
Also See for CRS:
- User manual (304 pages) ,
- Configuration manual (292 pages) ,
- Command reference manual (155 pages)
Table of Contents
Advertisement
Implementing MPLS Static Labeling
Example:
RP/0/RP0/CPU0:router(config)# mpls static
Enters MPLS-static configuration mode.
Step 3
interface interface
Example:
RP/0/RP0/CPU0:router(config-mpls-static)# interface gigabitethernet 0/0/0/3
Enables MPLS encapsulation on the specified interface.
Step 4
Use the commit or end command.
commit—Saves the configuration changes and remains within the configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration session.
• No—Exits the configuration session without committing the configuration changes.
• Cancel—Remains in the configuration session, without committing the configuration changes.
What to Do Next
To verify the interfaces on which MPLS is enabled, use the show mpls interfaces command from the EXEC
mode. For example:
RP/0/RP0/CPU0:router# show
Mon May 12 06:21:30.937 DST
Interface
-------------------------- -------- -------- -------- --------
GigabitEthernet0/0/0/3
For the interface on which MPLS static is enabled, the "Static" column displays "Yes".
Define a Range for Static MPLS Labels
The MPLS label range configuration defines the dynamic label range. Any label that falls outside this dynamic
range is available for manually allocating as static labels. The router does not verify statically-configured
labels against the specified label range. Therefore, to prevent label discrepancy, ensure that you do not configure
static MPLS labels that fall within the dynamic label range.
Note
The allocable range for MPLS labels is from 16 to 1048575. Label values from 0 to15 are reserved
according to RFC-3032.
SUMMARY STEPS
1. configure
2. mpls label range minimum_value maximum_value
3. Use the commit or end command.
mpls interfaces
LDP
Tunnel
Static
No
No
Yes
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Define a Range for Static MPLS Labels
Enabled
Yes
103
Advertisement
Table of Contents
