Configuring Auto-Tunnel Mesh Group - Cisco CRS Configuration Manual
Ios xr mpls configuration guide
Hide thumbs
Also See for CRS:
- User manual (304 pages) ,
- Configuration manual (292 pages) ,
- Command reference manual (155 pages)
Table of Contents
Advertisement
Configuring Auto-Tunnel Mesh Group
Command or Action
Related Topics
Auto-Tunnel Mesh, on page 206
Destination List (Prefix-List), on page 207
Configuring Auto-Tunnel Mesh Group
Perform this task to configure an auto-tunnel mesh group globally on the router.
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. auto-tunnel mesh
4. group value
5. disable
6. attribute-setname
7. destination-list
8. Use the commit or end command.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)# mpls traffic-eng
Step 3
auto-tunnel mesh
Example:
RP/0/RP0/CPU0:router(config-mpls-te)# auto-tunnel mesh
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
326
Implementing MPLS Traffic Engineering
Purpose
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Purpose
Enters global configuration mode.
Enters MPLS-TE configuration mode.
Enables auto-tunnel mesh groups globally.
Advertisement
Table of Contents
