Cisco CRS Configuration Manual page 307
Ios xr mpls configuration guide
Hide thumbs
Also See for CRS:
- User manual (304 pages) ,
- Configuration manual (292 pages) ,
- Command reference manual (155 pages)
Table of Contents
Advertisement
Implementing MPLS Traffic Engineering
SUMMARY STEPS
1. configure
2. mpls traffic-eng
3. auto-bw collect frequency minutes
4. Use the commit or end command.
5. show mpls traffic-eng tunnels [auto-bw]
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RP0/CPU0:router# configure
Step 2
mpls traffic-eng
Example:
RP/0/RP0/CPU0:router(config)# mpls
traffic-eng
RP/0/RP0/CPU0:router(config-mpls-te)#
Step 3
auto-bw collect frequency minutes
Example:
RP/0/RP0/CPU0:router(config-mpls-te)#
auto-bw collect frequency 1
Step 4
Use the commit or end command.
Purpose
Enters global configuration mode.
Enters MPLS-TE configuration mode.
Configures the automatic bandwidth collection frequency, and controls
the manner in which the bandwidth for a tunnel collects output rate
information; but does not adjust the tunnel bandwidth.
minutes
Configures the interval between automatic bandwidth adjustments
in minutes. Range is from 1 to 10080.
commit—Saves the configuration changes and remains within the
configuration session.
end—Prompts user to take one of these actions:
• Yes— Saves configuration changes and exits the configuration
session.
• No—Exits the configuration session without committing the
configuration changes.
• Cancel—Remains in the configuration session, without
committing the configuration changes.
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
Configuring the Automatic Bandwidth
289
Advertisement
Table of Contents
