Configuring Forwarding Over The Mpls-Te Tunnel - Cisco CRS Configuration Manual
Ios xr mpls configuration guide
Hide thumbs
Also See for CRS:
- User manual (304 pages) ,
- Configuration manual (292 pages) ,
- Command reference manual (155 pages)
Table of Contents
Advertisement
Configuring Forwarding over the MPLS-TE Tunnel
Command or Action
Step 8
show mpls traffic-eng tunnels
Example:
RP/0/RP0/CPU0:router# show mpls traffic-eng
tunnels
Step 9
show ipv4 interface brief
Example:
RP/0/RP0/CPU0:router# show ipv4 interface brief
Step 10
show mpls traffic-eng link-management
admission-control
Example:
RP/0/RP0/CPU0:router# show mpls traffic-eng
link-management admission-control
Related Topics
How MPLS-TE Works, on page 166
Build MPLS-TE Topology and Tunnels: Example, on page 342
Building MPLS-TE Topology, on page 213
Configuring Forwarding over the MPLS-TE Tunnel
Perform this task to configure forwarding over the MPLS-TE tunnel created in the previous task . This task
allows MPLS packets to be forwarded on the link between network neighbors.
Before You Begin
The following prerequisites are required to configure forwarding over the MPLS-TE tunnel:
• You must have a router ID for the neighboring router.
• Stable router ID is required at either end of the link to ensure that the link is successful. If you do not
Cisco IOS XR MPLS Configuration Guide for the Cisco CRS Router, Release 5.1.x
218
assign a router ID to the routers, the system defaults to the global router ID. Default router IDs are subject
to change, which can result in an unstable link.
Implementing MPLS Traffic Engineering
Purpose
• Cancel—Remains in the configuration mode, without
committing the configuration changes.
(Optional)
Verifies that the tunnel is connected (in the UP state) and
displays all configured TE tunnels.
(Optional)
Displays all TE tunnel interfaces.
(Optional)
Displays all the tunnels on this node.
Advertisement
Table of Contents
