Disassembling The Display Stand; How To Install - Pioneer PDP-425CMX Technical Manual
For pioneer plasma display monitor when used with video cards (expansion solutions cards)
Hide thumbs
Also See for PDP-425CMX:
- Technical manual (188 pages) ,
- Service manual (184 pages) ,
- Operating instructions manual (98 pages)
Table of Contents
Advertisement
Mobile Cart: PDK-5014
4.9.3 Disassembling the display stand
1 Remove the screws (four locations on the left and right
sides) then take off the bracket. For packing reasons,
the bracket is mounted at a different location then the
final installation location.
Bracket
Screws
4.9.4 How to install
In order to ensure safety during installation, always be sure to work with more than two people.
1 Assemble the unit
Attach the leg base to the display stand using the hexagonal bored bolts (M8 × 60) so that the rear label faces
towards the back casters (shown in the figure below).
Note
For safety, alternately tighten each bolt two times or more until they are firmly fixed in place.
84
Screws
Label
Display stand
2 Remove the rear cover.
Rear cover
Leg base
Back casters
Support caster
Do not take out the screws.
Loosen the
finger screws.
Washer
Plate spring washer
Hexagonal bored bolts
(M8 × 60)
- Quick Links:
- Specifications
- Controls and Connectors
Hide quick links:
Advertisement
Table of Contents
