Assembling The Mounting Hardware And Mounting The Plasma Display - Pioneer PDP-425CMX Technical Manual
For pioneer plasma display monitor when used with video cards (expansion solutions cards)
Hide thumbs
Also See for PDP-425CMX:
- Technical manual (188 pages) ,
- Service manual (184 pages) ,
- Operating instructions manual (98 pages)
Table of Contents
Advertisement
Tilt Mount Unit: PDK-5011
4.6.3 Assembling the mounting hardware and mounting the Plasma Display
1 Remove the special screws (2 locations) from the bot-
tom of the wall mounting unit.
Special screws (M6)
2 Remove the hardware on the wall side half and the
hardware on the PDP side half.
PDP side hardware
3 Attach the PDP side hardware to the Plasma Display.
Notes
• Place a sheet or protective cover to protect the
display from scratches or damage.
• Be sure to attach it on top of a flat table or similar
surface.
Top side of Plasma Display
66
Wall side hardware
PDP side hardware
4 Fix the Plasma Display to the PDP side hardware with
M8 bolts (6 locations).
Use the holes marked with the red triangle "%".
If the 42-inch model is installed with an inclination of
18° or more, the top part of the screw used to adjust
the angle may be visible from a horizontal position in
front of the screen. In this case, you can hide the top
of the screw by using the holes without a red triangle
mark "%".
Top side of Plasma Display
Note
Be sure to install speakers at this stage.
For the installation method, refer to the speaker
instruction manual.
5 Attach the wall side hardware to the wall.
Install the wall side hardware (4 locations) symmetri-
cally on the left and right side (one at each location
from the center of the
terial determines the type of screws and bolts (sold
separately) needed for this installation.
Note
Check the strength of the wall and beams before in-
stalling the display.
). Wall strength and ma-
- Quick Links:
- Specifications
- Controls and Connectors
Hide quick links:
Advertisement
Table of Contents
