Cisco Catalyst 2960 Command Reference Manual page 89

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Catalyst 2960 Switch Cisco IOS Commands

For physical interfaces:

When you define a range, you must enter a space before the hyphen (-), for example:

gigabitethernet0/1 - 2

You can also enter multiple ranges. When you define multiple ranges, you must enter a space after the

first entry before the comma (,). The space after the comma is optional, for example:

fastethernet0/3, gigabitethernet0/1 - 2

fastethernet0/3 -4, gigabitethernet0/1 - 2

This example shows how to create a multiple-interface macro:

Switch(config)# define interface-range macro1 fastethernet0/1 - 2, gigabitethernet0/1 - 2

Related Commands

interface range

show running-config

port-channel port-channel-number, where port-channel-number is from 1 to 6

fastethernet module/{first port} - {last port}

gigabitethernet module/{first port} - {last port}

module is always 0.

the range is type 0/number - number (for example, gigabitethernet 0/1 - 2).

Executes a command on multiple ports at the same time.

Displays the current operating configuration, including defined

macros. For syntax information, select Cisco IOS Configuration

Fundamentals Command Reference, Release 12.2 > File Management

Commands > Configuration File Management Commands.

Catalyst 2960 Switch Command Reference

define interface-range