Cisco 7962G Administration Manual page 77
For cisco unified communications manager 6.0
Hide thumbs
Also See for 7962G:
- Administration manual (235 pages) ,
- User manual (110 pages) ,
- Specifications (5 pages)
Table of Contents
Advertisement
Chapter 4
Configuring Settings on the Cisco Unified IP Phone
Table 4-2
Network Configuration Menu Options (continued)
Option
Description
DHCP Enabled
Indicates whether DHCP is being used by
the phone.
DHCP Address
Releases the IP address assigned by DHCP.
Released
Alternate TFTP
Indicates whether the phone is using an
alternative TFTP server.
SW Port
Speed and duplex of the network port
Configuration
(labeled 10/100 SW on the Cisco Unified
IP Phone 7962G and 7942G). Valid values:
Auto Negotiate
•
10 Half—10-BaseT/half duplex
•
10 Full—10-BaseT/full duplex
•
100 Half—100-BaseT/half duplex
•
100 Full—100-BaseT/full duplex
•
If the phone is connected to a switch,
configure the port on the switch to the same
speed/duplex as the phone, or configure
both to auto-negotiate.
If you change the setting of this option, you
should change the PC Port Configuration
option to the same setting. This ensures that
the PC receives the full benefits of the
network operating speed.
OL-12641-01
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 6.0
To Change
Unlock network configuration
1.
options.
Scroll to the DHCP Enabled
2.
option and press the No softkey
to disable DHCP, or press the Yes
softkey to enable DHCP.
Press the Save softkey.
3.
1.
Unlock network configuration
options.
2.
Scroll to the DHCP Address
Released option and press the
Yes softkey to release the IP
address assigned by DHCP, or
press the No softkey if you do not
want to release this IP address.
3.
Press the Save softkey.
Unlock network configuration
1.
options.
Scroll to the Alternate TFTP
2.
option and press the Yes softkey
if the phone should use an
alternative TFTP server. Press
the No softkey otherwise.
Press the Save softkey.
3.
Unlock network configuration
1.
options.
Scroll to the SW Port
2.
Configuration option and then
press the Edit softkey.
Scroll to the setting that you
3.
want and then press the Select
softkey.
Press the Save softkey.
4.
Network Configuration Menu
4-9
Advertisement
Table of Contents
Troubleshooting
