What Networking Protocols Are Used? - Cisco 7975G Software Manual
Administration guide for cisco unified communications manager 7.0 (sccp and sip)
Hide thumbs
Also See for 7975G:
- Software manual (302 pages) ,
- Administration manual (217 pages) ,
- Troubleshooting and maintenance (25 pages)
Table of Contents
Advertisement
What Networking Protocols Are Used?
What Networking Protocols Are Used?
Cisco Unified IP Phones support several industry-standard and Cisco networking protocols required for
voice communication.
Unified IP Phone 7975G supports.
Table 1-1
Supported Networking Protocols on the Cisco Unified IP Phone
Networking Protocol
Bootstrap Protocol (BootP)
Cisco Discovery Protocol
(CDP)
Dynamic Host Configuration
Protocol (DHCP)
Hypertext Transfer Protocol
(HTTP)
IEEE 802.1X
Cisco Unified IP Phone 7975G Administration Guide for Cisco Unified Communications Manager 7.0 (SCCP and SIP)
1-4
Table 1-1
provides an overview of the networking protocols that the Cisco
Purpose
BootP enables a network device such as the
Cisco Unified IP Phone to discover certain
startup information, such as its IP address.
CDP is a device-discovery protocol that runs
on all Cisco-manufactured equipment.
Using CDP, a device can advertise its
existence to other devices and receive
information about other devices in the
network.
DHCP dynamically allocates and assigns an
IP address to network devices.
DHCP enables you to connect an IP phone
into the network and have the phone become
operational without your needing to manually
assign an IP address or to configure additional
network parameters.
HTTP is the standard way of transferring
information and moving documents across the
Internet and the web.
The IEEE 802.1X standard defines a
client-server-based access control and
authentication protocol that restricts
unauthorized clients from connecting to a
LAN through publicly accessible ports.
Until the client is authenticated, 802.1X
access control allows only Extensible
Authentication Protocol over LAN (EAPOL)
traffic through the port to which the client is
connected. After authentication is successful,
normal traffic can pass through the port.
Chapter 1
An Overview of the Cisco Unified IP Phone
Usage Notes
If you are using BootP to assign IP addresses
to the Cisco Unified IP Phone, the BOOTP
Server option shows "Yes" in the network
configuration settings on the phone.
The Cisco Unified IP Phone uses CDP to
communicate information such as auxiliary
VLAN ID, per port power management details,
and Quality of Service (QoS) configuration
information with the Cisco Catalyst switch.
DHCP is enabled by default. If disabled, you
must manually configure the IP address,
subnet mask, gateway, and a TFTP server on
each phone locally.
Cisco recommends that you use DHCP
custom option 150. With this method, you
configure the TFTP server IP address as the
option value. For additional information
about DHCP configurations, refer to the
"Cisco TFTP" chapter in Cisco
Unified Communications Manager System
Guide.
Cisco Unified IP Phones use HTTP for the
XML services and for troubleshooting
purposes.
The Cisco Unified IP Phone implements the
IEEE 802.1X standard by providing support
for the EAP-MD5 option for 802.1X
authentication.
When 802.1X authentication is enabled on the
phone, you should disable the PC port and
voice VLAN. Refer to the
802.1X Authentication on Cisco Unified IP
Phones" section on page 1-15
information.
"Supporting
for additional
OL-15790-01
Advertisement
Table of Contents
Troubleshooting
