Table of Contents
Advertisement
Chapter 5
Maintaining the Router
Removing and Replacing Cards from the Line Card and RP Card
Cage
Caution
Step 1
Step 2
Step 3
OL-13832-01
This section describes the procedures for removing and installing a router
processor (RP) card or a line card. The line card and RP card cage has 10 slots
(numbered 0 through 9, from left to right). Line cards are installed in slots 0
through 7; RPs are installed in slots 8 and 9 (see
Handle all cards by the metal card carrier edges only; avoid touching the board or
any connector pins. After removing a card, carefully place it in an antistatic bag
or similar environment to protect it from ESD and dust in the optic ports
(fiber-optic line cards).
Use the following procedure to remove and replace a line card or RP from the card
cage:
Disconnect any cables from the card.
Remove the card:
Loosen the captive screws at the top and bottom of the front panel
a.
(Figure
5-23a).
Pivot the ejector levers to unseat the card from the backplane connector
b.
(Figure
5-23b.)
Slide the card out of the slot
c.
antistatic bag or other ESD-preventive container.
Replace the card by reversing the procedures in Steps 1 and 2.
Removing and Replacing Cards from the Chassis
Figure
(Figure
5-23c) and place it directly into an
Cisco XR 12410 Router Installation Guide
5-22).
5-39
Advertisement
Table of Contents
Troubleshooting
