Table of Contents
Advertisement
Chapter 5
Maintaining the Router
Eject the PEM from the chassis
Step 3
a.
b.
Note
Figure 5-17
Remove the clear plastic safety covers over the PDUs (see
Step 4
OL-13832-01
Removing and Replacing AC and DC Power Subsystem Components
Loosen the captive screw on the ejector lever and pivot the lever down to eject
the PEM from its bay.
Pull out the PEM halfway from its bay.
It is not necessary to completely remove the power supply. You can leave
the power supply in its bay while you replace the DC PDU.
Ejecting a DC PEM
(Figure
5-17):
Cisco XR 12410 Router Installation Guide
Figure
5-19).
5-29
Advertisement
Table of Contents
Troubleshooting
