Debug L3Tcam - Cisco Catalyst 3550 Command Reference Manual

Multilayer switch

Hide thumbs Also See for Catalyst 3550:

Table of Contents

Catalyst 3550 Switch Debug Commands

debug l3tcam

Use the debug l3tcam privileged EXEC command to enable debugging of the Layer 3 ternary content

addressable memory (TCAM) manager software module. This module controls the allocation of the part

of the TCAM used in IP unicast and multicast routing, including the allocation of both routes and

adjacencies in the TCAM. Use the no form of this command to disable debugging.

Syntax Description

This command has no arguments or keywords.

Debugging is disabled.

Command Modes

Privileged EXEC

Command History

Usage Guidelines

The undebug l3tcam command is the same as the no debug l3tcam command.

Related Commands

show debugging

debug l3tcam

no debug l3tcam

Modification

This command was introduced.

Displays information about the types of debugging that are enabled. For

syntax information, select Cisco IOS Release 12.2 Configuration Guides

and Command References > Cisco IOS Configuration Fundamentals

Configuration Guide, Release 12.2 > System Management >

Troubleshooting and Fault Management.

Catalyst 3550 Multilayer Switch Command Reference

debug l3tcam

Table of Contents