Interface Port-Channel - Cisco Catalyst 3550 Command Reference Manual
Multilayer switch
Hide thumbs
Also See for Catalyst 3550:
- Command reference manual (662 pages) ,
- Installation manual (154 pages) ,
- Hardware installation manual (106 pages)
Table of Contents
Advertisement
Chapter 2
Catalyst 3550 Switch Cisco IOS Commands
interface port-channel
Use the interface port-channel global configuration command to access or create the port-channel
logical interface for Layer 3 routed interfaces. Use the no form of this command to remove the
port-channel.
Syntax Description
port-channel-number
Defaults
No port-channel logical interfaces are defined.
Command Modes
Global configuration
Command History
Release
12.1(4)EA1
Usage Guidelines
For Layer 2 EtherChannels, you must configure the channel-group interface configuration command,
which automatically creates the port-channel logical interface. You cannot put Layer 2 interfaces into a
manually created port-channel interface.
You create Layer 3 port channels by using the interface port-channel command. You must manually
configure the port-channel logical interface before putting the interface into the channel group.
Only one port channel in a channel group is allowed.
When using a port-channel interface as a routed interface, do not assign Layer 3 addresses on the
Caution
physical interfaces that are assigned to the channel group.
Do not assign bridge groups on the physical interfaces in a channel group used as a Layer 3 port-channel
Caution
interface because it creates loops. You must also disable spanning tree.
Follow these guidelines when you use the interface port-channel command:
•
•
OL-8566-02
interface port-channel port-channel-number
no interface port-channel port-channel-number
Port-channel number. The range is 1 to 64.
Modification
This command was introduced.
If you configure Inter-Switch Link (ISL), you must assign the IP address to the switch virtual
interface (SVI).
If you want to use the CDP, you must configure it only on the physical interface and not on the
port-channel interface.
Catalyst 3550 Multilayer Switch Command Reference
interface port-channel
2-121
Advertisement
Chapters
Table of Contents
