Cisco Catalyst 3550 Command Reference Manual page 504

Multilayer switch

Hide thumbs Also See for Catalyst 3550:

Table of Contents

show storm-control

This is an example of output from the show storm-control command for a specified interface. Because

no traffic type keyword was entered, the broadcast storm control settings appear.

Switch> show storm-control fastethernet0/1

Filter State

Related Commands

storm-control

Catalyst 3550 Multilayer Switch Command Reference

Filter State

-------------

describes the fields in the show storm-control display.

show storm-control Field Descriptions

Displays the ID of the interface.

Displays the status of the filter:

Blocking—Storm control is enabled, and a storm has occurred.

Forwarding—Storm control is enabled, and no storms have occurred.

Inactive—Storm control is disabled.

Displays the rising suppression level as a percentage of total available

bandwidth or in packets per second.

Displays the falling suppression level as a percentage of total available

bandwidth or in packets per second.

Displays the bandwidth utilization of broadcast traffic or the specified traffic

type (broadcast, multicast, or unicast) as a percentage of total available

bandwidth or in packets per second. If storm control is disabled, this field

displays N/A (not applicable).

Configures the broadcast, the multicast, or the unicast storm control with the

specified suppression level.

Chapter 2 Catalyst 3550 Switch Cisco IOS Commands

Chapters

Table of Contents