Dot1X Pae - Cisco Catalyst 3550 Command Reference Manual

Multilayer switch

Hide thumbs Also See for Catalyst 3550:

Table of Contents

dot1x pae

Use the dot1x pae interface configuration command to configure the port as an IEEE 802.1x port access

entity (PAE) authenticator. Use the no form of this command to disable IEEE 802.1x authentication on

Syntax Description

This command has no arguments or keywords.

The port is not an IEEE 802.1x PAE authenticator, and IEEE 802.1x authentication is disabled on the

Command Modes

Interface configuration

Command History

Usage Guidelines

Use the no dot1x pae interface configuration command to disable IEEE 802.1x authentication on the

When you configure IEEE 802.1x authentication on a port, such as entering the dot1x port-control

interface configuration command, the switch automatically configures the port as an IEEE 802.1x

authenticator. After the no dot1x pae interface configuration command is entered, the Authenticator

PAE operation is enabled.

This example shows how to disable IEEE 802.1x authentication on the port:

Switch(config-if)# no dot1x pae

You can verify your settings by entering the show dot1x or show eap privileged EXEC command.

Related Commands

Catalyst 3550 Multilayer Switch Command Reference

dot1x pae authenticator

no dot1x pae

Modification

This command was introduced.

Catalyst 3550 Switch Cisco IOS Commands

Displays IEEE 802.1x statistics, administrative status, and

operational status for the switch or for the specified port.

Displays EAP registration and session information for the

switch or for the specified port.

Table of Contents