Ip Admission - Cisco Catalyst 3550 Command Reference Manual
Multilayer switch
Hide thumbs
Also See for Catalyst 3550:
- Command reference manual (662 pages) ,
- Installation manual (154 pages) ,
- Hardware installation manual (106 pages)
Table of Contents
Advertisement
Chapter 2
Catalyst 3550 Switch Cisco IOS Commands
ip admission
Command
show running-config
Use the ip admission interface configuration command to enable web authentication. You can also use
this command in fallback-profile mode. Use the no form of this command to disable web authentication.
Syntax Description
rule
Command Modes
Global configuration
Command History
Release
12.2(35)SE
Usage Guidelines
The ip admission command applies a web authentication rule to a switch port.
Examples
This example shows how to apply a web authentication rule to a switchport:
Switch# configure terminal
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# ip admission rule1
This example shows how to apply a web authentication rule to a fallback profile for use on an
IEEE 802.1x enabled switch port.
Switch# configure terminal
Switch(config)# fallback profile profile1
Switch(config)# ip admission name rule1
Switch(config)# end
Related Commands
Command
dot1x fallback
fallback profile
OL-8566-02
Description
Displays the running configuration on the switch. For syntax information,
select Cisco IOS Release 12.2 Configuration Guides and Command
References > Cisco IOS Configuration Fundamentals Command
Reference, Release 12.2 > File Management Commands >
Configuration File Management Commands.
ip admission rule
no ip admission
Apply an IP admission rule to the interface.
Modification
This command was introduced.
Description
Configure a port to use web authentication as a fallback method for clients
that do not support IEEE 802.1x authentication.
Enable web authentication on a port
Catalyst 3550 Multilayer Switch Command Reference
ip admission
2-131
Advertisement
Chapters
Table of Contents
