Table of Contents
Advertisement
ESU04091
Control rod adjustment
The weight transfer can be adjusted by turning the con-
trol rod adjuster or adjusting nut.
For RX10/RX10R/RX10RS
1. Loosen the locknut 1.
2. Turn the control rod adjuster 2 in direction a to
increase weight transfer or direction b to decrease
weight transfer.
CD-27E
Adjuster turning
direction
Weight transfer
3. Check the adjuster length c using the scale on the
special wrench 3 included in the owner's tool kit as
shown. Make sure that the rim d of the control rod
body is within the range e of the scale.
4. Tighten the locknut while holding the adjuster in
place.
Locknut tightening torque:
25 Nm (2.5 m·kgf, 18 ft·lb)
CAUTION :
@
When using the special wrench, make sure that it is
situated at a right angle to the control rod, and that it
is tightly fitted to the locknut or the control rod
adjuster.
@
WARNING
@
Never adjust the control rod beyond the range of the
scale on the special wrench.
@
8-27
←
a
Increased ←
→
b
→ Decreased
Advertisement
Table of Contents
