Cisco CRS-1 - Carrier Routing System Router Migration Manual page 56
Carrier routing system
Hide thumbs
Also See for CRS-1 - Carrier Routing System Router:
- Administration manual (436 pages) ,
- Getting started manual (289 pages) ,
- Troubleshooting manual (264 pages)
Table of Contents
Advertisement
How to Migrate to a Cisco CRS-3 Carrier Routing System (8-Slot)
Steps
To remove a CRS-1 fabric card, see
Figure 1-7
1
2
1
2
Step 1
Attach the ESD-preventive wrist strap to your wrist and connect its leash to an ESD connection socket
on the front of the chassis or to a bare metal surface on the chassis.
Step 2
Identify the card to be removed in the card cage. Use the screwdriver to turn the two captive screws on
the front panel of the card counterclockwise to loosen the card from the slot.
Grasp the two card ejector levers and simultaneously pivot both ejector levers about 90 degrees away
Step 3
from the front edge of the card carrier to unseat the card from the backplane connector.
Caution
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
1-46
Removing a CRS-1 Fabric Card
Captive screw
Ejector lever
To prevent ESD damage, handle a CRS-1 fabric card by its ejector levers, the CRS-1 fabric
card carrier edges, or the slide-assistance arm only. Do not touch any of the electrical
components, pins, and circuitry.
Chapter 1
Migrating to a Cisco CRS-3 Carrier Routing System
Figure 1-2
and follow these steps:
3
3
Direction of installation or removal
OL-13669-03
Advertisement
Chapters
Table of Contents
