Cisco CRS-1 - Carrier Routing System Router Migration Manual page 180
Carrier routing system
Hide thumbs
Also See for CRS-1 - Carrier Routing System Router:
- Administration manual (436 pages) ,
- Getting started manual (289 pages) ,
- Troubleshooting manual (264 pages)
Table of Contents
Advertisement
show controllers egressq port bpmap
show controllers egressq port bpmap
To display back pressure map table information of the egress queue manager, use the show controllers
egressq port bpmap command in EXEC mode.
Syntax Description
location node-id
Defaults
No default behavior or values.
Command Modes
EXEC
Command History
Release
Release 4.0.0.T
Release 4.0.1
Release 4.0.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes the proper
task IDs. If you suspect user group assignment is preventing you from using a command, contact your
AAA administrator.
Task ID
Task ID
drivers
Examples
The following example shows how to use the show controller egressq bpmap command:
RP/0/RP0/CPU0:router# show controller egressq port bpmap location 0/3/cpu0
---------------------------------------------------
---------------------------------------------------
Index
---------------------------------------------------
0
1
2
3
4
5
6
7
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
3-20
show controllers egressq port bpmap location node-id
Modification
This command was introduced.
No modification.
No modification.
Operations
read
Tor Asic HW BP Map Table Dump
Plim 0 Map
0
1
65535
2
3
65535
4
5
Chapter 3
Cisco CRS-3 Carrier Routing System Router Command Changes
Egress queue manager location.The node-id argument is entered in
the rack/slot/module notation.
Plim 1 Map
7
65535
8
9
65535
10
11
65535
OL-13669-03
Advertisement
Chapters
Table of Contents
