Verifying The Installation Of The Crs-1 Fabric Card - Cisco CRS-1 - Carrier Routing System Router Migration Manual
Carrier routing system
Hide thumbs
Also See for CRS-1 - Carrier Routing System Router:
- Administration manual (436 pages) ,
- Getting started manual (289 pages) ,
- Troubleshooting manual (264 pages)
Table of Contents
Advertisement
Chapter 2
Downgrading Your Cisco CRS-3 Carrier Routing System Router Back to a Cisco CRS-1 Carrier Routing
System Router
Note
Use the screwdriver to turn the two captive screws on the front panel of the CRS-1 fabric card clockwise
Step 13
to seat the card firmly in the slot.
What to Do Next
After performing this task, you may replace any front cosmetic cover plates (see the "Installing the Front
and Rear (SFC) Side Cosmetic Components" section in the Cisco CRS Carrier Routing System 16-Slot
Line Card Chassis Installation Guide).
For complete information on regulatory compliance and safety, see Regulatory Compliance and Safety
Information for the Cisco CRS Carrier Routing System. For information on removing the front cosmetic
cover plates, see the "Removing the Rear (OIM) Side Cosmetic Components" section in the Cisco CRS
Carrier Routing System 16-Slot Line Card Chassis Installation Guide. For information on how to power
down your chassis, see the "Powering an AC Power Shelf Energized Chassis Up and Down" section in
the Cisco CRS Carrier Routing System 8-Slot Line Card Chassis Installation Guide or the "Powering a
DC Power Shelf Energized Chassis Up and Down" section in the Cisco CRS Carrier Routing System
16-Slot Line Card Chassis Installation Guide. For information on installing an OIM, see the "Installing
an OIM" section in the Cisco CRS Carrier Routing System 16-Slot Line Card Chassis Installation Guide.
Verifying the Installation of the CRS-1 Fabric Card
This section describes how to verify that the CRS-1 fabric card has been properly installed.
is an illustration of the CRS-1 fabric card front panel.
Figure 2-5
Understanding the Alphanumeric LEDs
At one end of the faceplate, near an ejector lever, a CRS-1 fabric card has two four-digit alphanumeric
LED displays that show a sequence of messages indicating the state of the card. In normal operation, the
LED module should display
Note
It is normal for some displayed messages to appear too briefly in the LED display to be read.
Troubleshooting the CRS-1 Fabric Card
If the installed or replaced CRS-1 fabric card fails to operate or power up on installation:
OL-13669-03
Downgrading your Cisco CRS-3 Carrier Routing System 16-Slot Line Card Chassis Back to a Cisco CRS-1 Carrier
You may hear a crunching noise when seating the card; this noise is normal.
CRS-1 Fabric Card Front Panel
P I D / V I D
IOS-XR
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
.
Routing System 16-Slot Line Card Chassis
Figure 2-5
CRS-FCC-SFC
CLEI
SN:
2-13
Advertisement
Chapters
Table of Contents
