Required Tools And Equipment - Cisco CRS-1 - Carrier Routing System Router Migration Manual
Carrier routing system
Hide thumbs
Also See for CRS-1 - Carrier Routing System Router:
- Administration manual (436 pages) ,
- Getting started manual (289 pages) ,
- Troubleshooting manual (264 pages)
Table of Contents
Advertisement
How to Migrate to a Cisco CRS-3 Carrier Routing System (16-Slot)
Figure 1-1
Switch Fabric Card
Prerequisites
Before performing this task, you must first open the front cosmetic doors (if installed).
Caution
Use the slide-assistance arm to slide cards from the card carrier. DO NOT LIFT CARDS BY THE
SLIDE-ASSISTANCE ARM! Rotate cards onto their vertical axes, then lift them from the bottom, using
the slide-assistance arm only as an aid for balance.
Required Tools and Equipment
You need the following tools to perform this task:
•
•
Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide
1-28
ESD-preventive wrist strap
Large Phillips screwdriver
Chapter 1
Migrating to a Cisco CRS-3 Carrier Routing System
OL-13669-03
Advertisement
Chapters
Table of Contents
