Resetting Fspf To The Default Configuration; Enabling Or Disabling Fspf; Clearing Fspf Counters For The Vsan; Fspf Interface Configuration - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual
Cisco nexus 5000 series switch cli software configuration guide, nx-os 4.0(1a)n1 (ol-16597-01, january 2009)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Messages manual (518 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
Chapter 40
Configuring Fibre Channel Routing Services and Protocols
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Resetting FSPF to the Default Configuration
To return the FSPF VSAN global configuration to its factory default, perform this task:
Command
Step 1
switch# configuration terminal
Step 2
switch(config)# no fspf config vsan
vsan-id
Enabling or Disabling FSPF
To enable or disable FSPF routing protocols, perform this task:
Command
Step 1
switch# configuration terminal
Step 2
switch(config)# fspf enable vsan vsan-id
switch(config)# no fspf enable vsan
vsan-id
Clearing FSPF Counters for the VSAN
To clear the FSPF statistics counters for the entire VSAN, perform this task:
Command
switch# clear fspf counters vsan vsan-id
FSPF Interface Configuration
Several FSPF commands are available on a per-interface basis. These configuration procedures apply to
an interface in a specific VSAN.
This section includes the following topics:
•
•
•
•
•
•
OL-16597-01
About FSPF Link Cost, page 40-6
Configuring FSPF Link Cost, page 40-6
About Hello Time Intervals, page 40-6
Configuring Hello Time Intervals, page 40-6
About Dead Time Intervals, page 40-7
Configuring Dead Time Intervals, page 40-7
Purpose
Enters configuration mode.
Deletes the FSPF configuration for the specified
VSAN.
Purpose
Enters configuration mode.
Enables the FSPF routing protocol in the specified
VSAN.
Disables the FSPF routing protocol in the specified
VSAN.
Purpose
Clears the FSPF statistics counters for the specified
VSAN. If an interface reference is not specified, all
counters are cleared.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
FSPF Interface Configuration
40-5
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
