Verifying Fcoe Configuration - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual
Cisco nexus 5000 series switch cli software configuration guide, nx-os 4.0(1a)n1 (ol-16597-01, january 2009)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Messages manual (518 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
Verifying FCoE Configuration
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
switch# configure terminal
switch(config)# interface ethernet 1/2
switch(config-if)# lldp transmit
The following example shows how to configure an interface to disable LLDP:
switch# configure terminal
switch(config)# interface ethernet 1/2
switch(config-if)# no lldp transmit
switch(config-if)# no lldp receive
You can only apply this command to a physical Ethernet interface.
Verifying FCoE Configuration
To verify FCoE configuration information, perform one of these tasks:
Command
switch# show fcoe
switch# show lldp
The following example shows how to verify that the FCoE capability is enabled:
switch# show fcoe
FCoE/FC feature is desired.
The following example shows how to display LLDP interface information:
switch# show lldp interface ethernet 1/2
tx_enabled: TRUE
rx_enabled: TRUE
dcbx_enabled: TRUE
Port MAC address:
Remote Peers Information
No remote peers exist
The following example shows how to display LLDP neighbor information:
switch# show lldp neighbors
The following example shows how to display LLDP timer information:
switch# show lldp timers
LLDP Timers
holdtime 120 seconds
reinit 2 seconds
msg_tx_interval 30 seconds
The following example shows how to display LLDP counters:
switch# show lldp traffic
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
29-8
00:0d:ec:a3:5f:48
Chapter 29
Purpose
Displays whether FCoE is enabled on the switch.
Displays LLDP configuration.
Configuring FCoE
OL-16597-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
