Locking The Fabric; Committing Changes; Discarding Changes - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual
Cisco nexus 5000 series switch cli software configuration guide, nx-os 4.0(1a)n1 (ol-16597-01, january 2009)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Messages manual (518 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
Chapter 33
Configuring Domain Parameters
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
To enable (or disable) allowed domain ID list configuration distribution, perform this task:
Command
Step 1
switch# configuration terminal
switch(config)#
Step 2
switch(config)# fcdomain distribute
switch(config)# no fcdomain distribute
Locking the Fabric
The first action that modifies the existing configuration creates the pending configuration and locks the
feature in the fabric. After you lock the fabric, the following conditions apply:
•
•
Committing Changes
To apply the pending domain configuration changes to other SAN switches in the VSAN, you must
commit the changes. The pending configuration changes are distributed and, on a successful commit, the
configuration changes are applied to the active configuration in the SAN switches throughout the VSAN
and the fabric lock is released.
To commit pending domain configuration changes and release the lock, perform this task:
Command
Step 1
switch# configuration terminal
switch(config)#
Step 2
switch(config)# fcdomain commit vsan
vsan-id
Discarding Changes
At any time, you can discard the pending changes to the domain configuration and release the fabric lock.
If you discard (abort) the pending changes, the configuration remains unaffected and the lock is released.
To discard pending domain configuration changes and release the lock, perform this task:
Command
Step 1
switch# configuration terminal
switch(config)#
Step 2
switch(config)# fcdomain abort vsan
vsan-id
OL-16597-01
No other user can make any configuration changes to this feature.
A pending configuration is created by copying the active configuration. Subsequent modifications
are made to the pending configuration and remain there until you commit the changes to the active
configuration (and other switches in the fabric) or discard them.
Purpose
Enters configuration mode.
Enables domain configuration distribution.
Disables (default) domain configuration
distribution.
Purpose
Enters configuration mode.
Commits the pending domain configuration changes.
Purpose
Enters configuration mode.
Discards the pending domain configuration changes.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Domain IDs
33-11
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
