About Vsan Creation; Creating Vsans Statically - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual
Cisco nexus 5000 series switch cli software configuration guide, nx-os 4.0(1a)n1 (ol-16597-01, january 2009)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Messages manual (518 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
Configuring VSANs
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
•
•
•
•
•
•
•
•
•
•
•
•
•
About VSAN Creation
A VSAN is in the operational state if the VSAN is active and at least one port is up. This state indicates
that traffic can pass through this VSAN. This state cannot be configured.
Creating VSANs Statically
You cannot configure any application-specific parameters for a VSAN before creating the VSAN.
To create VSANs, perform this task:
Command
Step 1
switch# configuration terminal
Step 2
switch(config)# vsan database
switch(config-vsan-db)#
Step 3
switch(config-vsan-db)# vsan vsan-id
Step 4
switch(config-vsan-db)# vsan vsan-id name
name
updated vsan 2
Step 5
switch(config-vsan-db)# vsan vsan-id
suspend
Step 6
switch(config-vsan-db)# no vsan vsan-id
suspend
Step 7
switch(config-vsan-db)# end
switch#
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
37-6
Creating VSANs Statically, page 37-6
About Port VSAN Membership, page 37-7
Assigning Static Port VSAN Membership, page 37-7
Displaying VSAN Static Membership, page 37-7
About the Default VSAN, page 37-8
About the Isolated VSAN, page 37-8
Displaying Isolated VSAN Membership, page 37-8
Operational State of a VSAN, page 37-9
About Static VSAN Deletion, page 37-9
Deleting Static VSANs, page 37-10
About Load Balancing, page 37-10
Configuring Load Balancing, page 37-10
About Interop Mode, page 37-11
Chapter 37
Configuring and Managing VSANs
Purpose
Enters configuration mode.
Configures the database for a VSAN. Application
specific VSAN parameters cannot be configured
from this prompt.
Creates a VSAN with the specified ID if that
VSAN does not exist already.
Updates the VSAN with the assigned name.
Suspends the selected VSAN.
Negates the suspend command issued in the
previous step.
Returns you to EXEC mode.
OL-16597-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
