Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual page 73
Cisco nexus 5000 series switch cli software configuration guide, nx-os 4.0(1a)n1 (ol-16597-01, january 2009)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Messages manual (518 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
Chapter 3
Configuring the Switch
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Mgmt0 IPv4 address: ip_address
Enter yes (yes is the default) to configure the IPv4 default gateway (recommended).
Step 9
Configure the default-gateway: (yes/no) [y]: yes
Enter the default gateway IPv4 address.
a.
IPv4 address of the default-gateway: default_gateway
Enter yes (yes is the default) to enable the Telnet service.
Step 10
Enable the telnet service? (yes/no) [y]: yes
Enter yes (no is the default) to enable the SSH service.
Step 11
Enabled SSH service? (yes/no) [n]: yes
Enter the SSH key type that you would like to generate.
Step 12
Type the SSH key you would like to generate (dsa/rsa/rsa1)? dsa
Step 13
Enter the number of key bits within the specified range.
Enter the number of key bits? (768 to 2048): 768
Step 14
Enter yes (no is the default) to configure the NTP server.
Configure NTP server? (yes/no) [n]: yes
a.
Enter the NTP server IPv4 address.
NTP server IP address: ntp_server_IP_address
Step 15
Enter yes (yes is the default) to configure basic Fibre Channel configurations.
Enter basic FC configurations (yes/no) [n]: yes
Step 16
Enter shut (shut is the default) to configure the default Fibre Channel switch port interface to the shut
(disabled) state.
Configure default physical FC switchport interface state (shut/noshut) [shut]: shut
Step 17
Enter on (on is the default) to configure the switch port trunk mode.
Configure default physical FC switchport trunk mode (on/off/auto) [on]: on
Enter permit (deny is the default) to deny a default zone policy configuration.
Step 18
Configure default zone policy (permit/deny) [deny]: permit
Permits traffic flow to all members of the default zone.
If you are executing the setup script after entering a write erase command, you explicitly must change
Note
the default zone policy to permit for VSAN 1 after finishing the script using the following command:
switch(config)# zone default-zone permit vsan 1
Step 19
Enter yes (no is the default) to enable a full zone set distribution.
Enable full zoneset distribution (yes/no) [n]: yes
Overrides the switch-wide default for the full zone set distribution feature.
You see the new configuration. Review and edit the configuration that you have just entered.
OL-16597-01
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Initial Configuration
3-11
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
