Configuring Cfs Over Ip; Enabling Cfs Over Ip - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual
Cisco nexus 5000 series switch cli software configuration guide, nx-os 4.0(1a)n1 (ol-16597-01, january 2009)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Messages manual (518 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
Configuring CFS over IP
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
Deleting CFS Regions
Deleting a region is nullifying the region definition. All the applications bound by the region are released
back to the default region by deleting that region.
To delete a region, for example, a region numbered 4, perform this task:
Command
Step 1
switch# configure
Step 2
switch(config)# no cfs region region-id
Note
After Step 2, you see the warning, "All the applications in the region will be moved to the default region."
Configuring CFS over IP
The following sections provide information about configuring CFS over IP:
•
•
•
•
Enabling CFS over IP
Note
To enable or disable CFS over IPv4, perform this task:
Command
Step 1
switch# configure
Step 2
switch(config)# cfs ipv4 distribute
switch(config)# no cfs ipv4 distribute
To enable or disable CFS over IPv6, perform this task:
Command
Step 1
switch# configure
Step 2
switch(config)# cfs ipv6 distribute
switch(config)# no cfs ipv6 distribute
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
21-12
Enabling CFS over IP, page 21-12
Verifying the CFS Over IP Configuration, page 21-13
Configuring IP Multicast Address for CFS over IP, page 21-13
Verifying IP Multicast Address Configuration for CFS over IP, page 21-14
CFS cannot distribute over both IPv4 and IPv6 from the same switch.
Chapter 21
Purpose
Enters configuration mode.
Deletes the region.
Purpose
Enters configuration mode.
Globally enables CFS over IPv4 for all applications
on the switch.
Disables (default) CFS over IPv4 on the switch.
Purpose
Enters configuration mode.
Globally enables CFS over IPv6 for all applications
on the switch.
Disables (default) CFS over IPv6 on the switch.
Using Cisco Fabric Services
OL-16597-01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
