Table of Contents
Advertisement
Chapter 5
Migrating to Solaris 10 and Cisco PGW 2200 Softswitch Software Release 9.8
Step 13
Restart PGW host 2 in order to ensure that the changes to the pom.dataSync variable take effect.
Migration from Release 9.7 to Release 9.8 without Platform
Changes
Perform the following procedure to migrate from Cisco PGW 2200 Softswitch Release 9.7 to
Release 9.8 without platform changes:
When replicating the calls from release 9.7 to release 9.8 , some calls will be lost due to the architectural
Note
changes between release 9.7 and release 9.8.
Note
As you migrate from Cisco PGW 2200 Softswitch Release 9.7(3) to Release 9.8(1), before you start the
Release 9.8(1) system software, first install the base Release of 9.8(1), and then install Release 9.8(1)
patch S7P7 or later.
Log in the Cisco PGW 2200 Softswitch as mgcusr.
Step 1
Enter the following command to stop the Cisco PGW 2200 Softswitch software:
Step 2
% sudo /etc/init.d/CiscoMGC stop
Delete the replication between the active and standby pair of the Cisco PGW 2200 Softswitches.
Step 3
% ./delete_replication.sh
Step 4
Back up the .odbc.ini file manually using the following command:
% cp /opt/CiscoMGC/local/.odbc.ini /opt/CiscoMGC/etc/.odbc.ini.ttdb
Step 5
Locate the active configuration using the following commands:
% cd /opt/CiscoMGC/etc
% cd active_link
% pwd
The text similar to the following is displayed:
/opt/CiscoMGC/etc/CONFIG_LIB/CFG_Sip
Back up the active configuration using the following commands:
Step 6
% cd /opt/CiscoMGC/etc/CONFIG_LIB
% tar cvf CFG_backup973.tar ./CFG_Sip
Back the snmp folder using the following command:
Step 7
% cd /opt/CiscoMGC
% tar cvf SNMP_backup973.tar ./snmp
Step 8
Back the dial plan configurations using the following commands:
% cd /opt/CiscoMGC
% tar cvf DP_backup973.tar ./dialPlan
OL-18083-14
Migration from Release 9.7 to Release 9.8 without Platform Changes
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
5-21
Advertisement
Table of Contents
