Table of Contents
Advertisement
Chapter 5
Migrating to Solaris 10 and Cisco PGW 2200 Softswitch Software Release 9.8
Note
If you want to use two new disk drives to install the Cisco PGW 2200 Softswitch software Release 9.8,
you can use the original disk drives to revert to the previous Cisco PGW 2200 Softswitch software
version if there is a problem during the upgrade procedure. For instructions on how to revert to the
previous Cisco PGW 2200 Softswitch software version, see the
Cisco PGW 2200 Softswitch Release 9.5 or 9.6" section on page
If you are upgrading from the primary disk, use Veritas Volume Manager to use the second disk for
Note
Solaris 8 fallback. For further information, refer to
http://www.sun.com/products-n-solutions/hardware/docs/Software/Storage_Software/VERITAS_Volu
me_Manager/index.html.
Shut down PGW host 2:
Step 1
# init 0
Step 2
Wait for the system to return to the boot prompt and load the Cisco Solaris 10 Operating System Startup
CD in the CD-ROM drive.
Note
Install the Sun Solaris 10 operating system using the procedures in the
Step 3
Operating System" section on page
Caution
Loading the Sun Solaris 10 Operating Environment Packages
Before you install the Cisco PGW 2200 Softswitch software, load the Sun Solaris 10 Operating
Environment packages using the steps in the
section.
Caution
Do not load Solstice DiskSuite (CSCOh023) if you are using Veritas Volume Manager to use the second
disk for Solaris 8 fallback. For more information about Veritas Volume Manager, refer to
http://www.sun.com/products-n-solutions/hardware/docs/Software/Storage_Software/VERITAS_Volu
me_Manager/index.html.
OL-18083-14
If you are replacing the disk drives, power off the system and label, and remove the existing
disks, using proper anti-static procedures. Install the new disk drives in the same slots the
original disk drives were located. Finally, power up the system. For more information, see the
Sun System Manual for your platform.
Do not format or modify the second disk drive. Unless you replaced the disk drives in
the second disk contains the original Solaris 8 system if you are using Veritas Volume
Manager. The second disk is used as a fallback in case of a failure in the Solaris 10 upgrade.
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
Migration from Release 9.5 or 9.6 to Release 9.8 without Platform Changes
2-3.
"Loading the Sun Solaris 10 Operating
"Falling Back to Solaris 8 and
5-29.
"Loading the Sun Solaris 10
Environment"
Step
2,
5-9
Advertisement
Table of Contents
