Table of Contents
Advertisement
Chapter 3
Installing the Cisco PGW 2200 Softswitch Software Release 9.8 and Higher
Note
After the installation of the Cisco PGW 2200 Softswitch software, you may see the following
informational messages at login:
hostagt: GetSNMPPort: no snmp entry in /etc/services
hostagt: snmp port is 161 from #define SNMP_PORT
Ignore these messages.
Installing the Cisco PGW 2200 Softswitch Software Release 9.8
and Higher Releases
Before you begin this procedure, the Solaris 10 operating system and Solaris 10 operating environment
Note
should be already installed on your system.
Note
Remove /usr/ucb from the path environment variable before the initial installation of the
Cisco PGW 2200 Softswitch software. However, if /usr/ucb is needed, make sure that it is located in the
path variable in the user profile after /usr/sbin.
In order for you to enable the SIP Improved Failover Support feature, both Cisco PGW 2200 Softswitch
Note
systems must be in the same Virtual LANs (VLANs). A trunk line between the two switches must be
connected and configured for the SIP Improved Failover Support feature to work. However, if SIP
Improved Failover Support is not required on your system, then the trunk line is not mandatory.
Installing Cisco PGW 2200 Softswitch Software on a Simplex System
To install the Cisco PGW 2200 Softswitch software, complete the following steps:
Log in as root.
Step 1
Load the Cisco PGW 2200 Softswitch software CD into the CD-ROM drive.
Step 2
Enter the following commands:
Step 3
# cd /cdrom/cdrom0
# ./install.sh
The following prompt is displayed:
Use supplied admin file for unattended install? [n] [y,n,?,q]
Step 4
Enter y to perform an unattended installation. If you answer n, you must answer prompts and press Enter
for each package that is installed.
The following prompt is displayed:
Base directory for Toolkit (default /opt/Toolkit) [?,q]
OL-18083-14
Installing the Cisco PGW 2200 Softswitch Software Release 9.8 and Higher Releases
at line 118 in file getport.c
at line 123 in file getport.c
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
3-3
Advertisement
Table of Contents
