Table of Contents
Advertisement
Installing the Cisco PGW 2200 Softswitch Software Release 9.8 and Higher Releases
Step 5
Press Enter to accept the default directory for the Toolkit.
Text similar to the following is displayed:
##########################################################################################
# The CSCOgu000 utilities package must be installed prior to other components
# but has not been detected on your system.
# parameters necessary for installing the rest of your software.
# this package, the installation script will exit.
##########################################################################################
Would you like to install it now? [y] [y,n,?,q]
Enter y to install the CSCOgu000 utilities package on this host.
Step 6
The system begins to display various configuration settings for the Cisco PGW 2200 Softswitch
Step 7
software. We recommend that you accept the default values (by pressing Enter). You can, however,
specify a different user ID and a group ID. If the ID you specify already exists on the system, the existing
ID is reused, or you are prompted to enter another ID. The configuration settings are as follows:
Base directory for CiscoMGC (default /opt/CiscoMGC) [?,q]
Enter CiscoMGC user name [mgcusr]
Enter CiscoMGC UID [20000]
Enter CiscoMGC group name [mgcgrp]
Enter CiscoMGC GID [20000]
WARNING: setting mode of </etc/init.d/inetinit> to default mode (644)
[mgcgrp] group added
[mgcusr] user added
Modifying /etc/init.d/inetinit
Caution
The system returns the following message, stating that the CSCOgu000 utilities package was
successfully installed:
Installation of <CSCOgu000> was successful.
If the system indicates that you need to reboot after installing the utilities package, proceed to Step 8a.
Step 8
Otherwise, proceed to Step 9.
Note
a.
Enter the command displayed on the screen and press Enter.
# shutdown -y -g0 -i6
Note
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
3-4
Chapter 3
No validation is performed on the IDs you enter. If you enter an invalid ID, the utilities
package does not add any accounts.
Rebooting may take approximately 5 minutes.
If the command shown on the screen does not work, you can enter the /usr/sbin/reboot
command to reboot the system.
Installing the Cisco PGW 2200 Softswitch Software Release 9.8 and Higher
This package contains all required system
If you do not install
OL-18083-14
#
#
#
#
Advertisement
Table of Contents
