Table of Contents
Advertisement
Chapter 2
Installing the Sun Solaris 10 Operating System
Do you want to remove this package? [y,n,?,q] y
...
Removal of <CSCOh023> was successful.
This completes the DiskSuite removal.
Installing the Log and Spool File Systems (CSCOh024)
This section applies to a Cisco PGW 2200 Softswitch host with 18-GB disk drives running the
Note
Cisco PGW 2200 Softswitch software.
If the DiskSuite software is installed and configured, you must first follow the procedure in the
Note
"Removing the Solstice DiskSuite" section on page 2-70
configuring the second disk to be used for the log and spool file systems.
To determine whether DiskSuite is installed and configured, run the /usr/sbin/metastat command. If the
command is found and it displays the status of mirrors, it indicates that DiskSuite is installed and
configured.
Note
For the device names for each platform type, see
Host
This procedure enables you to move the log and spool file system to the second disk drive to increase
the capacity for log, alarm, measurement, and CDR files. This improves the performance of the host. If
CSCOh024 is not installed, your system continues to store log and spool files on the first disk drive. The
second disk is defined into two partitions:
•
•
Table 2-3
disk drives.
Table 2-3
Slice No.
0
1
2
3
OL-18083-14
(sparc,i386) 3.0(6)
Platforms).
The first partition is the log partition and uses about 30 percent of the disk.
The second partition is the spool partition that uses 50percent of the disk.
and
Table 2-4
shows sample partition tables for disks 1 and 2 for a Netra t 1400 with 18-GB
18-GB Disk 1 Partition Table (Cisco PGW 2200 Softswitch with Log and Spool
Package)
Cisco PGW 2200 Softswitch Host
Slice Name
/
/var
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
Loading the Sun Solaris 10 Operating Environment
to remove the DiskSuite software before
Table 2-1 on page 2-3 (Device Names on the Supported
Slice Size (GB)
1.00
1.40
0.00
0.00
2-71
Advertisement
Table of Contents
