Table of Contents
Advertisement
Chapter 4
Configuring the Cisco PGW 2200 Softswitch Software
Table 4-3
Table 4-3
Parameter
*.CPUTimerInterval
*.desiredPlatformState
*.IP_Addr1 through IP_Addr4
*.IP_AddrLocalA and
*.IP_AddrLocalB
*.IP_AddrPeerA and
*.IP_AddrPeerB
*.MGC_CDR_NODE_ID
*.ownTranspathId
*.peerTranspathId
*.platformId
OL-18083-14
shows the Cisco PGW 2200 Softswitch configuration parameters.
Configuration Parameters
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
Initial Cisco PGW 2200 Softswitch Software Configuration
Description
Samples the frequency of CPU utilization.
Prior to Release 9.4(1), this parameter must be set to 0
during the initial configuration of any platform with a
single CPU (including Sun Netra t 100/105, Sun
Netra V 120, and Sun Netra 120).
Default: 3000 msec (3 seconds)
During the startup of the
Note
Cisco PGW 2200 Softswitch software, this
parameter will be set automatically to tune the
system for optimal performance.
For Release 9.4(1) and later, this parameter is set
automatically when you specify a
Cisco PGW 2200 Softswitch type in the
engine.SysVirtualSwitch parameter. Any attempt to
modify this parameter is overwritten.
Specifies the operating mode of the
Cisco PGW 2200 Softswitch.
Specify the IP addresses being used by the system.
Note that *.IP_AddrLocalA, and *.IP_AddrLocal2 are
the same as *.IP_Addr1, and *.IP_Addr2, respectively.
The local IP addresses of the
Cisco PGW 2200 Softswitch. These addresses should
match the value of *.IP_AddrLocalA and
*.IP_AddrLocalB.
The IP address of Cisco PGW 2200 Softswitch peers
used for failover.
The Cisco PGW 2200 Softswitch System ID used for
Call Data Records (CDRs).
Contains a unique number that identifies the
Cisco PGW 2200 Softswitch's virtual switch controller
within the ASN (Auxiliary Signaling Network).
Default: 01
Contains a unique number that identifies a peer virtual
switch controller within the ASN (Auxiliary Signaling
Network).
Default: 02
Identifies the Cisco PGW 2200 Softswitch platform.
The default value 1 applies to Fault Tolerant mode and
Standalone mode.
Default: 1
4-5
Advertisement
Table of Contents
