Table of Contents
Advertisement
Chapter 3
Installing the Cisco PGW 2200 Softswitch Software Release 9.8 and Higher
Would you like to add a protocol set to your system? [y] [y,n,?,q]
Step 9
Select y to add a protocol set.
Note
The protocols that you select are specific to your system requirements. These should be decided prior to
installation.
The following prompt is displayed:
Please insert a two digit package identifier and type <enter>
If you choose to add all protocols to your system, type "all": <package identifier>
Step 10
You can do either of the following:
a.
Enter all and press Enter to add all of the protocols to your system. If you do, more disk space is
used and the installation process takes more time. Proceed to
b.
Select the specific protocol(s) you need from the tables (instead of selecting all) and enter the
protocol identifier(s).
The following prompt is displayed:
Would you like to add another protocol set to your system? [y] [y,n,?,q]
Select one of the following options:
Step 11
a.
If you select y, you are prompted by the system to enter another protocol identifier (see
b.
If you select n, the system begins installing the protocols you specify, resulting in text similar to the
following for each protocol group:
Uncompressing ISUPV2_AUSTRIAN.mdo
Uncompressing ISUPV2_AUSTRIAN.so
Uncompressing ISUPV2_CZECH.mdo
Uncompressing ISUPV2_CZECH.so
Uncompressing ISUPV2_DUTCH.mdo
Uncompressing ISUPV2_DUTCH.so
Uncompressing ISUPV2_FINNISH96.mdo
Uncompressing ISUPV2_FINNISH96.so
Uncompressing ISUPV2_FRENCH.mdo
Uncompressing ISUPV2_FRENCH.so
Uncompressing ISUPV2_GERMAN.mdo
Uncompressing ISUPV2_GERMAN.so
Uncompressing ISUPV2_ISRAEL.mdo
Uncompressing ISUPV2_ISRAEL.so
Installation of <CSCO40000> was successful.
Once the all of your selected protocol groups have been installed, the system displays text similar to the
following:
Beginning Check of System Performance Requirements
Number of CPUs in system
Memory size: 2048 Megabytes
The sparcv9 processor operates at 1336 MHz,
Swap is total: 76384k bytes allocated + 13744k reserved = 90128k used, 5635696k available
Please Verify that you have over 4000000K Available swap
The tt60 daemon has stopped successfully.
Installation completed Wed Sep 24 03:52:32 EDT 2008
OL-18083-14
Installing the Cisco PGW 2200 Softswitch Software Release 9.8 and Higher Releases
2
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
Step
12.
Step
10).
3-11
Advertisement
Table of Contents
