Installing The Chassis In The Rack - Cisco Router 7204 Installation And Configuration Manual
Cisco systems router installation and configuration guide
Hide thumbs
Also See for Router Cisco 7204:
- Installing (21 pages) ,
- Installation and configuration manual (192 pages) ,
- Regulatory compliance and safety information manual (76 pages)
Table of Contents
Advertisement
Rack-Mounting the Cisco 7204
( D R A F T L A B E L ) A L P H A D R A F T - C I S C O C O N F I D E N T I A L
Figure 3-9
Rack-mount
bracket
Thread two M4 x 8-mm Phillips flathead screws through the rack-mount bracket and into the side of the
Step 3
chassis. Use a number 2 Phillips screwdriver to tighten the screws.
Repeat
Step 4
If you plan to include the cable-management brackets in your rear rack-mount configuration, align the
Step 5
first cable-management to the threaded holes in the front sides of the chassis. (Refer to
Figure
Thread two M4 x 8-mm Phillips flathead screws through the bracket and into the chassis. Use a number
Step 6
2 Phillips screwdriver to tighten the screws.
Repeat Step 5 and Step 6 for the other cable-management brackets.
Step 7
This completes the procedure for installing the rack-mount brackets and cable-management brackets on
the Cisco 7204. Proceed to the following section
Warning
To prevent injury, review the safety precautions in
installing the router in a rack.
Installing the Chassis in the Rack
After installing the brackets on the chassis, mount the router by securing the rack-mount brackets to two
posts or mounting strips in the rack using the six slotted screws provided. Because the brackets support
the weight of the entire chassis, be sure to use all six slotted screws to fasten the two rack-mount brackets
to the rack posts.
19-inch, 4-post and 2-post equipment racks.
We recommend that you allow at least one or two inches of vertical clearance between the router and any
equipment directly above and below it.
To maintain a low center of gravity, ensure that heavier equipment is installed near the bottom of the
Warning
rack.
Cisco 7204 Installation and Configuration Guide
3-8
Installing the Rack-Mount Brackets on the Rear of the Chassis so the Front
is Recessed in the Rack
Step 1
through
Step 3
for the other rack-mount bracket.
3-9.)
Figure
3-2,
Figure
SERIAL-EIA/TIA-232
Cable-management
bracket
"Installing the Chassis in the
Chapter 2, "Preparing for Installation"
3-3,
Figure
3-4, and
Figure 3-5
Chapter 3
Installing the Cisco 7204
Cisco 7200
SERIES
ETHERNET-10BFL
FAST ETHERNET INPUT/OUTPUT CONTROLLER
Figure 3-8
Rack."
show typical installations in
and
before
OL-5101-02
Advertisement
Table of Contents
Troubleshooting
