Reformatting A Flash Memory Card - Cisco Router 7204 Installation And Configuration Manual
Cisco systems router installation and configuration guide
Hide thumbs
Also See for Router Cisco 7204:
- Installing (21 pages) ,
- Installation and configuration manual (192 pages) ,
- Regulatory compliance and safety information manual (76 pages)
Table of Contents
Advertisement
Reformatting a Flash Memory Card
Use the following series of commands to designate the file new.image (which is on the Flash memory
Step 5
card in slot 0) as the default boot image:
Router# config t
Router(config)# no boot system
Router(config)# boot system flash slot0:new.image
Router(config)# ^z
Router# copy running-config startup-config
Router# reload
When the system reloads, it will boot the file new.image from the Flash memory card in slot 0.
This completes the procedure for copying bootable images between Flash memory cards.
Reformatting a Flash Memory Card
Depending on the circumstances, you might need to use a Flash memory card from another system to
copy images or backup configuration files; however, you cannot boot from a Flash memory card that was
formatted on another type of system. You must reformat the card before you can use it as a boot source.
(Use only Intel Series 2+ Flash memory cards.)
Note
To avoid potential problems when inserting spare Flash memory cards in your Cisco 7204, we
recommend that you reformat all of your Flash memory cards on a Cisco 7204 running one of the
recommended Cisco IOS software releases listed in Software Advisor.
The following formatting procedure erases all information on the Flash memory card. To prevent the loss
Caution
of important data that might be stored on a Flash memory card, proceed carefully. If you want to save
the data on a Flash memory card, copy the data to a server before you format the card.
The reformatting procedure assumes the following:
•
•
•
Use the following procedure to reformat a Flash memory card:
Step 1
Insert the Flash memory card into slot 0. (If slot 0 is not available, use slot 1.) (Refer to the earlier section
"Installing and Removing a Flash Memory Card" section on page
Cisco 7204 Installation and Configuration Guide
6-12
You have already booted your Cisco 7204.
You have access to a TFTP server (meaning you know its name and have connectivity to it) and at
least one interface is available over which you can access this server, or a secondary Flash memory
card available in slot 0 or slot 1 onto which you can copy files.
To ensure access to a TFTP sever, you will need to configure at least one network interface
Note
using the setup command facility. For instructions on using this procedure, refer
toChapter 4, "Performing a Basic Configuration of the Cisco 7204."
You know the filename of the image you want you want to copy to the TFTP server or onto the
secondary Flash memory card.
Chapter 6
Maintaining the Cisco 7204
6-7.)
OL-5101-02
Advertisement
Table of Contents
Troubleshooting
