Configuring The Cisco 7204 Manually Using The Setup Facility; Configuring Global Parameters - Cisco Router 7204 Installation And Configuration Manual
Cisco systems router installation and configuration guide
Hide thumbs
Also See for Router Cisco 7204:
- Installing (21 pages) ,
- Installation and configuration manual (192 pages) ,
- Regulatory compliance and safety information manual (76 pages)
Table of Contents
Advertisement
Configuring the Cisco 7204
At the # prompt enter the following command:
Step 3
Hostname# copy running-config startup-config
Note
Configuring the Cisco 7204 Manually Using the Setup Facility
If you do not plan to use AutoInstall, do not connect the router's serial (WAN) cable to the channel
service unit/data service unit (CSU/DSU). If the serial (WAN) cable is connected to the CSU/DSU and
the router does not have a configuration stored in NVRAM, the router attempts to run AutoInstall at start
up. The router may take several minutes to determine that AutoInstall is not set up to a remote TCP/IP
host.
Once the router determines that AutoInstall is not configured, it will default to the setup facility. If the
serial (WAN) cable is not connected, the router will boot from Flash memory and go automatically into
the setup facility.
Note
You can run the setup facility any time you are at the enable prompt (#) by entering the command setup.
Configuring Global Parameters
When you first start the setup program, you must configure the global parameters. These parameters are
used for controlling system-wide settings. Complete the following steps to enter the global parameters:
Step 1
Connect a console terminal to the console port on the I/O controller, and then boot the router.
The system boots from Flash memory. The following information appears after about 30 seconds. When
you see this information, you have successfully booted your router:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-J-M), Released Version 11.1(17)CA
Copyright (c) 1986-1996 by cisco Systems, Inc.
Compiled Sun 21-Apr-96 04:10 by
Image text-base: 0x60010890, data-base: 0x605F0000
ROM: System Bootstrap, Version 11.1(17)CA, RELEASED SOFTWARE
ROM: 7200 Software (C7200-J-M), Released Version 11.1(17)CA
router uptime is 8 minutes
Cisco 7204 Installation and Configuration Guide
4-4
Completing this step saves the configuration settings that the AutoInstall process created to
NVRAM. If you fail to do this, your configuration will be lost the next time you reload the router.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Chapter 4
Performing a Basic Configuration of the Cisco 7204
OL-5101-02
Advertisement
Table of Contents
Troubleshooting
