Configuring Interfaces - Cisco Router 7204 Installation And Configuration Manual
Cisco systems router installation and configuration guide
Hide thumbs
Also See for Router Cisco 7204:
- Installing (21 pages) ,
- Installation and configuration manual (192 pages) ,
- Regulatory compliance and safety information manual (76 pages)
Table of Contents
Advertisement
Chapter 4
Performing a Basic Configuration of the Cisco 7204
The enable password is used when there is no enable secret
and when using older software and some boot images.
Enter enable password: betty
Enter virtual terminal password: fred
Configure SNMP Network Management? [yes]:
Configure IP? [yes]:
Configure Vines? [no]:
Configure IPX? [no]: y
Configure AppleTalk? [no]: y
Configure Apollo? [no]:
Configure DECnet? [no]:
Configure XNS? [no]:
Configure CLNS? [no]:
Configure bridging? [no]:
Step 10
Save your settings to NVRAM. (Refer to the
later in this chapter.)
Configuring Interfaces
Following are the steps for configuring interfaces to allow communication over a LAN or WAN. To
configure the interface parameters, you need your interface network addresses and subnet mask
information. Consult with your network administrator for this information.
Configuring Ethernet Interfaces
Step 1
In the following example, the system is being configured for an Ethernet LAN using IP. Respond to the
prompts as follows, using your own addresses and mask at the setup prompts:
Configuring interface parameters:
Configuring interface Ethernet0/0:
Is this interface in use? [yes]:
Use the 100 Base-TX (RJ-45) connector? [yes]:
Configure IP on this interface? [no]: yes
Determine if you are going to enable IPX on this interface; if you are, enter the unique IPX network
Step 2
number:
Configure IPX on this interface? [no]: yes
Step 3
If you will be using AppleTalk on the interface, enter yes. Enter yes to configure for extended AppleTalk
networks, and then enter the cable range number. Enter the zone name and any other additional zones
that will be associated with your local zone:
Configure AppleTalk on this interface? [no]: yes
OL-5101-02
Community string [public]:
Configure IGRP routing? [yes]:
Your IGRP autonomous system number [1]: 15
Multizone networks? [no]: y
IP address for this interface: 1.1.1.10
Number of bits in subnet field [0]:
Class A network is 1.0.0.0, 0 subnet bits; mask is 255.0.0.0
IPX network number [2]:
Extended AppleTalk network? [no]: yes
AppleTalk starting cable range [0]:
"Saving Your Settings to NVRAM" section on page
Cisco 7204 Installation and Configuration Guide
Configuring the Cisco 7204
4-10"
4-7
Advertisement
Table of Contents
Troubleshooting
