Connecting Power; Connecting Ac-Input Power - Cisco Router 7204 Installation And Configuration Manual
Cisco systems router installation and configuration guide
Hide thumbs
Also See for Router Cisco 7204:
- Installing (21 pages) ,
- Installation and configuration manual (192 pages) ,
- Regulatory compliance and safety information manual (76 pages)
Table of Contents
Advertisement
Connecting Power
( D R A F T L A B E L ) A L P H A D R A F T - C I S C O C O N F I D E N T I A L
Examine the sequence of colored wires to determine the type of RJ-45 cable as follows:
•
•
Connecting Power
Warning
Read the installation instructions before you connect the system to its power source.
This section provides the procedures for connecting AC-input and DC-input power to your Cisco 7204.
Detailed instructions for handling and replacing the Cisco 7204 power supplies are contained in the
Note
configuration notes 280-Watt AC-Input Power Supply Replacement Instructions and 280-Watt DC-Input
Power Supply Replacement Instructions. These documents are available on Cisco.com.
Only trained and qualified personnel should be allowed to install or replace this equipment.
Warning
Connecting AC-Input Power
Connect a 280W AC-input power supply as follows:
At the rear of the router, check that the power switch on the power supply is in the OFF (O) position.
Step 1
Slide the cable-retention clip up, away from the AC receptacle, and plug in the power cable.
Step 2
Step 3
Secure the cable in the power supply AC receptacle by sliding the cable-retention clip up until it fits
around the connector. The cable-retention clip provides strain relief for the AC power cable (refer to
Figure
Note
Cisco 7204 Installation and Configuration Guide
3-20
Straight-through—The colored wires are in the same sequence at both ends of the cable.
Crossover—The first (far left) colored wire at one end of the cable is the third colored wire at the
other end of the cable, and the second colored wire at one end of the cable is the sixth colored wire
at the other end of the cable.
3-20).
For additional AC power cable strain relief, secure the cable to the power supply handle by
inserting a nylon cable tie through the hole in the handle and around the cable.
Chapter 3
Installing the Cisco 7204
OL-5101-02
Advertisement
Table of Contents
Troubleshooting
