Cisco Router 7204 Installation And Configuration Manual page 84
Cisco systems router installation and configuration guide
Hide thumbs
Also See for Router Cisco 7204:
- Installing (21 pages) ,
- Installation and configuration manual (192 pages) ,
- Regulatory compliance and safety information manual (76 pages)
Table of Contents
Advertisement
Connecting Power
( D R A F T L A B E L ) A L P H A D R A F T - C I S C O C O N F I D E N T I A L
Figure 3-21 Stripping the DC-Input Leads
0.55 in.
(14 mm)
At the rear of the router, check that the power switch on the power supply is in the OFF (O) position
Step 3
(refer to
Insert the stripped end of the ground lead all the way into the ground lead receptacle on the DC-input
Step 4
power supply and tighten the receptacle screw using a 3/16-inch flat-blade screwdriver (refer to
Figure
Figure 3-22 Connecting DC-Input Power
Step 5
Insert the stripped end of the +48V lead all the way into the +48V lead receptacle and tighten the
receptacle screw using the same 3/16-inch flat-blade screwdriver. Repeat this step for the -48V lead.
Note
After tightening the receptacle screw for the ground, +48V, and –48V DC-input leads, use the cable tie
Step 6
you saved earlier in this procedure to secure the three leads to the power supply faceplate.
Cisco 7204 Installation and Configuration Guide
3-22
Figure
3-22).
3-22).
Power switch
Cable tie
Ground lead
service loop
DC power leads
Make sure the entire stripped end of each lead is inserted all the way into its receptacle. If any
exposed wire at the stripped end of a lead is visible after inserting the lead into its receptacle,
remove the lead from the receptacle, use the wire stripper to cut the stripped end of the lead, and
repeat
Step 2
through
Step
5.
Chapter 3
Installing the Cisco 7204
OL-5101-02
Advertisement
Table of Contents
Troubleshooting
