Installing The Router Chassis In The Rack - Cisco ASR 903 Installation Manual
Aggregation services router hardware
Hide thumbs
Also See for ASR 903:
- Release notes (280 pages) ,
- Hardware installation manual (196 pages) ,
- Manual (147 pages)
Table of Contents
Advertisement
Installing the Router Chassis in the Rack
Figure 49: Attaching Mounting Brackets for a 19-inch EIA Rack
The figure below shows how to attach the brackets on the Cisco ASR 903 Router for a 300 mm ETSI cabinet.
Figure 50: Attaching Mounting Brackets for a 300 mm ETSI Cabinet
Step 2
Position one of the brackets against the chassis side, and align the screw holes.
Step 3
Secure the bracket to the chassis with the screws removed when performing Step 1 . The recommended maximum torque
is 28 in.-lb (3.16 N-m).
The A903-FAN-E fan tray with filter (A903-FAN-F) cannot be mounted using the mounting screws that are supported
for A903-FAN fan tray. This is not an issue with the FAN tray filter blank panel (A903-FAN-F-B). We recommend that
you use the short screws provided in the following rack mount kits to avoid interference of the air filter during rack
mounting and while replacing the fan tray (A903-FAN) with the fan tray (A903-FAN-E):
• 19" rack mount kit (A903-RCKMT-19IN)
• ETSI rack mount kit (A903-RCKMT-ETSI)
What to do next
Repeat Step 2 and Step 3 for the other bracket.
Installing the Router Chassis in the Rack
The procedures in this section apply to both horizontal and vertical mounting of the router in a rack.
To install the router chassis in the equipment rack, perform these steps:
Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide
72
Installing the Cisco ASR 903 Router
Advertisement
Table of Contents
