Cisco ASR 903 Installation Manual page 130
Aggregation services router hardware
Hide thumbs
Also See for ASR 903:
- Release notes (280 pages) ,
- Hardware installation manual (196 pages) ,
- Manual (147 pages)
Table of Contents
Advertisement
Installing the Cisco ASR 903 Router
32 x T1/E1 Cable Connector
Figure 83: 16 x T1/E1 Cable Connector
The figure below shows how the cable is connected between the 16 x T1/E1 interface module and the patch
panel.
Figure 84: Cable Installation between 16 x T1/E1 Interface and Patch Panel
1
Patch panel interfaces
For information about the pinout of the cable connecting the T1/E1 interface to the rear of the patch panel,
see the Troubleshooting.
32 x T1/E1 Cable Connector
The 32 x T1/E1 interface module requires two patch cables (see
Recommended Patch
Panel). Each patch
cable (see the figure below ) has a 68-pin connectors that connects with each connector port on the front panel
of the 32 x T1/E1 interface module.
Use the thumbscrews on either side of the connectors to secure the cable to the interface.
Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide
120
Advertisement
Table of Contents
