Mounting The Router In A Rack; Installing The Router Chassis In The Rack - Cisco ASR 920 Series Installing Manual
Hide thumbs
Also See for ASR 920 Series:
- Configuration manual ethernet router (438 pages) ,
- Configuration manual (68 pages) ,
- Configuration (52 pages)
Table of Contents
Advertisement
Installing the Cisco ASR 920 Series Router
1
Phillips flat-head screws
3
Mid-mounting position
Mounting the Router in a Rack
Perform the steps given below to mount the router into the equipment rack.
Note
To secure the router to the equipment rack, you must use the two mounting screws (provided) for each side
or follow your local practices for installing the router into your equipment rack. Ensure that the rack-mount
brackets are securely fastened. For more information, see the Attaching Brackets to the Router section.
Procedure
Step 1
Locate the equipment rack position where you plan to install the router.
Step 2
Verify that there are no obstructions and ensure that the equipment rack is stabilized.
Step 3
Determine whether you are mounting the router on a 19-inch, 23-inch, or an ETSI rack. Rack-Mounting
Brackets figure shows the types of mounting brackets.
Step 4
Determine the mounting position (Front-, Mid-, or Rear-mounting) of the router. (For 19-inch racks, see
Attaching Brackets for 19-Inch Racks section. For 23-inch racks, see Attaching Brackets for 23-Inch Racks
section. For ETSI racks, see Attaching Brackets for ETSI Racks section.)
Step 5
Locate the mounting holes of the router.
Step 6
Align the rack-mounting bracket with the router and position with the four #6-32 x 0.25-inch screws (provided).
Step 7
Insert the screws (four places) and tighten using a Number 2 Phillips screwdriver (each side).
Step 8
Position the router in the equipment rack lining up the bracket holes on the router with the holes on the rack
and secure with four #6-32 x 0.25-inch mounting screws (two on each side).
Step 9
Tighten the screws using a 1/4-inch flat-blade screwdriver (each side). The recommended maximum torque
is 10 in.-lb.
Installing the Router Chassis in the Rack
Note
Ensure adequate air flow when mounting the router in a rack. For more information, see the Air Flow Guidelines
section in the Cisco ASR-920-12SZ-IM and ASR-920U-12SZ-IM Aggregation Services Router Hardware
Installation Guide.
2
Front-mounting position
4
Rear-mounting position
Mounting the Router in a Rack
Installing the Cisco ASR 920 Series Router
7
Hide quick links:
Advertisement
Table of Contents
